In today's lesson i made a tree which was made out of a cylinder and 3 cones which I edited the side and height segments so it would be more squared off the smooth and round, I adjusted the height segments from 5 to 3 and the side segments from 24 to 7, this gave it the effect I wanted and reduced the poly count from 2,160 to 448.
 |
| Rough tree |
 |
| detailed tree |
I also made a pumpkin Which I made two different versions one normal pumpkin and one with a face in it. I made this using a sphere which I squished a little bit so it wasn't a perfect sphere and then I put it into edit mesh and beveled it so it would have indents in it. I then put a small sphere inside it so it would be hollow. I then added a stalk which was made out of two cylinder and a sphere which gave it a curve so it didn't look to straight and perfect.
 |
| Plain pumpkin |
I then made shapes and used Boolean to make the carvings in the pumpkin. (might not be able to see it very well)
 |
| carving 1 |
No comments:
Post a Comment